As stated in this post
Meaning myself and others can help you better, if you can help us better understand your set up and the problem you’re facing. The information you’ve shared so far is not sufficient to provide any meaningful guidance.
You said you were following the Raspberry Pi (RPi) guide for setting up a Google Coral EdgeTPU, but you’re using a Intel device, so not a Raspberry Pi. That guide is specific for RPi, and if that’s not what you’re using, then it’s unlikely to be relevant. Most likely you’ll need to seek out documentation/support for EdgeTPU setup for your device. A good place to start is probably the EdgeTPU repository and maybe take a look at this issue.